环境烟草烟气粒径分布及其对光散射的影响

为了测量典型办公室内环境中环境烟草烟气悬浮颗粒物的数浓度和粒径分布变化,以及其对颗粒光散射的影响,在6.8 m×3.2mx2.8 m的试验间进行试验,采用测量范围为5～1 000 nm的DMS500扫描电迁移率粒径谱仪进行粒径测量.结果表明,不同卷烟样品的烟气粒径分布曲线近似,都可以用对数正态分布函数来描述.4种卷烟样品粒径分布及参数变化速率相似,在4 800 s内数中值粒径CMD平均值从105 nm增大至155 nm,几何标准差GSD平均值从1,58减小至1.45,CMD和GSD的变化趋势近似符合指数函数.利用基于Mueller光散射理论的程序计算烟颗粒对散射光的影响.粒径分布的变化显著改变了颗粒散射光强度,CMD最大使散射光强度增大7倍,GSD引起的强度变化较小.综合考虑烟气颗粒数浓度降低和粒径分布的变化,散射光强度最大增大3倍.     

BiOCl/TiO_2复合材料的可见光活性及机理研究

采用水热法和溶胶凝胶法制备新型BiOCl/TiO2复合材料并明确了最优的掺杂比例(2%).随后利用X射线衍射(XRD)、紫外可见漫反射(DRS)、透射电镜(TEM)和X射线光电子能谱(XPS)对该材料进行表征.由于禁带宽度较大,纯BiOCl和TiO2的可见光催化性能极差,然而二者复合后,同条件下的苯降解率却大幅提升,可以达到40%以上.经证实,催化剂制备过程中,Bi的状态发生变化,在TiO2导、价带之间插入新的能级,使其禁带宽度变窄,电子可以实现可见光跃迁.     

Synthesis, crystal structure, photodegradation kinetics and photocatalytic activity of novel photocatalyst ZnBiYO4

ZnBiYO₄ was synthesized by a solid-state reaction method for the first time. The structural and photocatalytic properties of ZnBiYO₄ were characterized by X-ray diffraction, scanning electron microscopy, X-ray photoelectron spectroscopy and UV-Vis diffuse reflectance. ZnBiYO₄ crystallized with a tetragonal spinel structure with space group I41/A. The lattice parameters for ZnBiYO₄ were a = b = 11.176479 Å and c= 10.014323 Å. The band gap of ZnBiYO₄ was estimated to be 1.58 eV. The photocatalytic activity of ZnBiYO₄ was assessed by photodegradation of methyl orange under visible light irradiation. The results showed that ZnBiYO₄ had higher catalytic activity compared with N-doped TiO₂ under the same experimental conditions using visible light irradiation. The photocatalytic degradation of methyl orange with ZnBiYO₄ or N-doped TiO₂ as catalyst followed first-order reaction kinetics, and the first-order rate constant was 0.01575 and 0.00416 min^-1 for ZnBiYO₄ and N-doped TiO₂, respectively. After visible light irradiation for 220 min with ZnBiYO₄ as catalyst, complete removal and mineralization of methyl orange were observed. The reduction of total organic carbon, formation of inorganic products, SO₄^2- and NO₃^-, and evolution of CO₂ revealed the continuous mineralization of methyl orange during the photocatalytic process. The intermediate products were identified using liquid chromatography- mass spectrometry. The ZnBiYO₄/(visible light) photocatalysis system was found to be suitable for textile industry wastewater treatment and could be used to solve other environmental chemical pollution problems.     

Ecotect在建筑玻璃幕墙光反射影响评价中的应用研究

将Ecotect软件应用到建筑玻璃幕墙光反射影响评价中,应用结果表明,Ecotect软件能准确地确定建筑玻璃幕墙反射光的影响范围,且能准确地确定幕墙遮阳设施或周围建筑的遮挡效果,这可大大加强建筑玻璃幕墙光反射影响评价的准确性.另外,Ecotect软件还可准确地分析出受影响的敏感目标或敏感目标受照反射光的来源,这可使幕墙设计者有针对性对受影响敏感目标或对敏感目标产生反射光影响的建筑玻璃幕墙立面采取预防控制措施,来降低或者消除光反射,从而从源头上减少或消除幕墙反射光对周围环境敏感目标的影响.     

染料探针技术对二级出水中优势污染物的定量检测

分别以刚果红和中性红为染料探针,建立了牛血清蛋白质(BSA)和海藻酸多糖(SA)含量与共振光散射(RLS)发射光谱强度间的线性关系;以甲苯胺蓝为染料探针,建立了腐殖酸(HA)含量与紫外吸光度间的线性关系;优化了3种标准物质的检测浓度范围及溶液p H值条件;考察了染料探针分析方法对标准物的二元和三元混合样品中的回收率.结果表明在适宜的浓度范围内,BSA、HA、SA浓度与染料探针光谱强度间的线性相关系数R0.98,3种标准物在混合样品中的回收率不小于95%,标准误差低于0.11%.以紫外光谱和3D-EEM光谱特征作为城市污水二级出水样品中蛋白质、多糖和腐殖酸的定性依据,确认了4种二级出水样品中的优势污染物.通过染料-探针技术与国标法测得的多糖和蛋白质质量浓度的相对偏差在1.2%~0.04%之间.     

滇池水体除藻材料的除藻作用试验研究

利用昆明地区的粘土矿制作新型轻质除藻材料,试验研究该材料对滇池湖水中藻类的除藻及净化作用.实验室小试(20 L)结果表明,该除藻材料放入滇池水样实验70 d后,水质明显好转,藻类去除率可达95.8%,CODMn、TN及TP的去除率分别为34.4%、81.5%、28.2%.在滇池湖边300 m2水面围栏扩大试验结果显示,除藻材料放入试验区水体10 d后,水体中藻类含量明显减少,水体透光率从55%增加到80%,水质状况也有很大改善.研究结果表明,该材料具有良好的湖泊水体除藻及净化作用,有必要对其开展进一步的深入研究.     

清浊分流条件下的混凝-臭氧处理棉针织印染清废水

根据污染源头控制和废水回用的要求,对典型棉针织染整厂的不同生产过程废水排水水质特征进行了统计分析,提出了较实用的废水源头清浊分流方案。在此基础上重点研究了混凝-臭氧组合工艺对清废水处理效果,确定了最优的工艺条件。结果表明,清废水主要为洗水,占废水总量的25%～30%;混凝-臭氧组合工艺的最优工艺条件为：pH为6～9,PAC投加量为48 mg/L,PAM投加量为1.0 mg/L,臭氧接触时间为12 min（臭氧浓度为14.5 mg/L）,这时,清废水COD、色度去除率分别为71%和98%,实践证明,出水水质完全能够满足染整生产。     

氮掺杂TiO2可见光光催化剂的制备及性能

以尿素和钛酸丁酯为原料,通过溶胶-凝胶法低温下制备了高可见光催化活性的氮掺杂TiO2(NDT)光催化剂,采用XRD、TEM、BET和UV-Vis DRS等测试手段对其进行了表征,并在自制光催化反应器中降解甲基橙评价了样品的光催化活性。结果表明,当氮与钛的摩尔比为0.5∶1时,350℃焙烧的样品(NDT350)具有最佳的可见光光谱吸收和光催化活性,该催化剂为锐钛矿晶相,平均粒径为21 nm,比表面积为89.13 m2/g。可见光辐照下,NDT350降解甲基橙的表观反应速率常数为1.381×10-2min-1,是商业P25催化剂的16.85倍。NDT350优良的可见光催化活性与其大的比表面积和强烈的可见光光谱吸收有关。     

Phototransformation of herbicide metsulfuron methyl

Phototransformation of the herbicide metsulfuron methyl was investigated on glass surface under sunlight and ultraviolet (UV) light and compared with dark condition. The half-lives of metsulfuron methyl under UV light and sunlight were found to be 0.5 and 7.8 days respectively. Rate of phototransformation followed first order kinetics with significant correlation coefficient. The major photoproducts were identified as methyl-2-sulfonyl-amino-benzoate, 2-amino-6-methoxy-4-methyltriazine and saccharin (O-sulfobenzoimide). Various metabolites from this study were identified by high performance liquid chromatography (HPLC). Authentic samples required for HPLC comparison were prepared in laboratory and characterized on the basis of nuclear magnetic resonance (NMR) and infra red (IR) spectral data. These metabolites were also identified from metsulfuron methyl treated wheat field soil.     

Fe^3＋掺杂TiO2/凹凸棒复合材料的光催化性能

采用酸催化的溶胶-凝胶法制备了一系列Fe^3＋掺杂TiO2/凹凸棒（Fe^3＋-TiO2/ATP）复合光催化剂材料。在可见光条件下,以亚甲基蓝（MB）溶液的光催化降解反应,评价了样品的光催化性能,研究了TiO2负载量、Fe^3＋掺杂量和焙烧温度对复合材料光催化性能的影响。在单因素实验的基础上,采用正交实验设计（L25（53））优化了催化剂的制备条件。光催化实验结果表明,MB在复合材料上的光催化降解反应遵循Langmuir-Hinshelwood（L-H）动力学模型。正交实验结果表明,当TiO2负载量为15%、Fe^3＋掺杂量为0.5%和焙烧温度为550℃时,得到的复合材料对MB的光催化降解效率最佳,测得表观反应速率常数kapp为6.09×10^-3min^-1,反应4 h后MB的降解率（Dt）可达75.88%,相同实验条件下与P25（1.51×10^-3min^-1）相比较,反应速率提高了4.03倍,降解率提高了45.05%。另外,复合材料的沉降性能优于P25,易于分离,是一类有应用前景的复合光催化剂。敏世雄王芳魏立强王永生冯雷佟永纯韩玉琦